Airwheel S6 self-balancing electric scooter does well in providing riders’ satisfactory experience, as riders can ride in two very different configurations, depending on how they feel most comfortable: either sit on the ergonomic saddle or stand on the platform by pressing the seat with legs to go forward and backword. This is mainly because of the control panel and transformer board. Do you know how to change them?
Video Link: http://www.youtube.com/embed/xzMYE72-zMU
To replace the control panel and transformer board, you need to remove the cushion, remove the supporting rod of the saddle and remove the upper cover screw.
Then, remove the cover and disconnect the power cord, remove the control board. Record the wiring position in the control board, and then remove the control board.
The next step is to remove the transformer board. Before removing the transformer board, record the wiring position. Replace the transformer board and fix the transformer board and connect wires as recorded. Organize wires.
Then, you need to replace the control panel and fix control board. Refer to the previous record, arrange and fix the wirings. Connect the power cord. After replacing the new control board, the vehicle needs to be calibrated. Turn on the power, short connect the J3 interface as shown in the figure.
Shorten the J3 interface and e press the remote control A key to start. A few seconds later, disconnect it and wait for calibration to complete
Lastly, you need to install the upper cover, install the supporting rod of the saddle and install the saddle to finish the operation.
If the words make you feel boring, you can visit the https://www.youtube.com/watch?v=ZkrmPErbpQs to have a more vivid description of Airwheel S6 self-balancing scooter.
Video Link: http://www.youtube.com/embed/ZkrmPErbpQs
Company Name: Airwheel Holding Limited
Contact Person: Eric
Country: United States